Ntpdate not updating time

Posted by / 05-Nov-2017 07:26

Ntpdate not updating time

The cost is a little processing power and memory, but for a modern server this is negligible. Approved by Ubuntu Technical Board # on 2011-02-08 (LP: #104525). server 0.server 1.server 2.server 3.remote refid st t when poll reach delay offset jitter ============================================================================== stratum2-2. 1.70 2 u 5 64 377 68.461 -44.274 110.334 ntp2.m-online.n 212.18.1.106 2 u 5 64 377 54.629 -27.318 78.882 *145.2 . but the time never updates, it always stays on the incorrect time (it seems to be pulling time from the ESXi host on reboot unless i set it with ntpdate) I have unticked the box to get the time from the host. 1 u 22 64 377 8.661 -0.036 0.126 -ISP1 2.2.2.2 2 u 36 64 377 11.720 -0.027 0.280 #PRIVATE7 . Note that it can take several minutes before your NTP server is able to provide time services to downstream clients.First, check the stratum level of your server: ass ID=0 status=c011 sync_alarm, sync_unspec, 1 event, event_restart,version="ntpd [email protected] Tue Jul 6 UTC 2010 (1)",processor="x86_64", system="Linux/2.6.32-200.19.1.el6uek.x86_64",leap=11, stratum=16, precision=-20, rootdelay=0.000,rootdispersion=1.020, peer=0, refid=INIT,reftime=00000000.00000000 Thu, Feb 7 2036 .000, poll=6,clock=d21d4a96.a26c5962 Fri, Sep 16 2011 .634, state=0,offset=0.000, frequency=0.000, jitter=0.001, noise=0.001,stability=0.000, tai=0 , wait a few minutes and try again.$ sudo ntpdate org 31 Aug ntpdate[8911]: the NTP socket is in use, exiting $ sudo service ntp stop [ ok ] Stopping NTP server: ntpd.$ sudo ntpdate org 31 Aug ntpdate[10355]: adjust time server .115 offset -0.002893 sec $ sudo service ntp start For people reading the way above, though it technically works, look below at superuser.com/a/639516/308927 because it's way simpler (single command, no need to twiddle with stopping/starting the service).

I would check the 2 other boxes DC1 & 3 to ensure they are getting the correct time. 1 u 40 64 377 9.468 0.209 0.129 -PRIVATE3 1.1.1.1 2 u 12 64 377 6.943 -0.270 0.142 -PRIVATE5 .

This post will explain how to configure NTP on your Oracle VM Manager to provide time services.

Prior to starting this process, you should ensure that your Oracle VM Manager host is either registered with the Unbreakable Linux Network (ULN) or configured to use Oracle's public yum service.

You may want to check with your network administrator if time services are provided on your corporate network and replace these entries.

To change your upstream time servers, search /etc/for: And replace with entries that refer to your local time server names or IP addresses.

ntpdate not updating time-32ntpdate not updating time-31ntpdate not updating time-30

Behind this simple description, there is a lot of complexity - there are tiers of NTP servers, with the tier one NTP servers connected to atomic clocks, and tier two and three servers spreading the load of actually handling requests across the Internet.

One thought on “ntpdate not updating time”